the controller for gold pieces of rusty machine production facilities. It also can be set up two sets of gold film rust generation methods, production for the combination of the two group mode; if only the production need a way to group two gold pieces of rusty generation set to exactly the same line;
the controller panel is provided with six keys, a liquid crystal display screen. Following the method of operation:
, set the internal parameters of the
controller with the press' modify 'key, open the power supply controller, then release the' modify 'bond; namely, enters the internal parameter setting interface; rust film coefficient: piece of fixed value, this value is greater, the stepper motor swing more this parameter is usually large; manufacturers to design machine set. Motor speed: this value is greater, the greater the stepper motor speed; manufacturers this parameter in general pattern machine set. Press the 'up' and 'down' key to move the cursor position, press the '-' and '-' button to modify the cursor location content;
foot: 'open': hold down the pedal switch can make sheet; 'off': not according to trample on the switch or cut off the foot switch. Press "confirm" key to exit.
note: flakes of rust, motor speed coefficient value cannot be 0;
two, machining parameters
1, click on the 'modified' button, the cursor on the display;
2, according to the 'left' or ',' key, move around the cursor;
3, press the 'up' or 'down arrow' key, make the cursor position data plus or minus;
4, continue to press the '-' '-' 'up' or 'down' button to modify other location data;
5, press the 'confirm' keys, exit slit like and joint amplitude condition, the cursor disappears.
note: the cursor in the 'number of slices of the tablets' words, according to the' 'key, counting the number zero flakes of rust.
three, installation:
1, three core power line is connected with the AC 220V
2, four core white aerial plug 42 stepper motor, stepper motor each phase current 1. 7A. If you turn right motor, the control box is connected with a stepper motor driver and two white lines can be reversed. Holzer sensing plate
3, 9 core flat plug to the
4 control panel, control panel installation:
Holzer sensor for detecting the spindle speed, spindle is provided with two magnetic steel, a magnetic steel N pole outward, a magnetic steel S pole outward, two magnetic steel position spaced about 180 DEG; Holzer sensor alignment magnetic steel the spindle rotates a circle, Holzer sensor receives a S signal and an N pole magnet signal.
note:
1: hand slowly rotating spindle, the feed stepper motor, stepper motor as the return of material; the back material of stepper motor, stepper motor for feeding; turn right into the description of step motor, the control box is connected with a stepper motor driver and two white swap.
2: step motor feeding or discharging the timing is wrong, need to adjust the position of the magnetic steel.
3: stepper motor continues to send material, material return; consists of the following reasons:
a: Holzer sensing plate bad;
b: Holzer sensing plate is too far away from the magnetic steel;
c: two magnetic steel is not a N pole outward, an S pole outward;
d: rust film coefficient control panel the set to 0;
e: motor speed control panel is set to 0;
f: control box stepper motor drive bad;
g: stepper motor bad. Line
h: bad or mechanical failure;
4: step into motor rotation amplitude wrong; consists of the following reasons:
a: control panel seam width coefficient setting value is wrong;
b: the fine fraction of incorrect control box stepper motor driver, should toggle drive 1, 2, 3 of the three position switch, design as the 16 subdivision;
c: set the current control box of stepping motor driver is too small; it should toggle drive 5, 6, 7 of the three position switch, so that the current is set to 1. 7A.
d: motor speed control panel set value is too small
|
|
|
|
|
|
|
| |
|
| |
