Zhongshan Bilang Technology Co. Ltd.   

high temperature heat pump (air source) is the principle of high temperature heat pump can produce as high as 85 degrees -90 degrees of high temperature hot water and high temperature hot air heat pump units, compared with the direct heating energy saving more than 60% of the equipment; of which: high-temperature heat pump drying room is used to heat pump heating equipment, supporting good by heat preservation board + drying equipment. Working principle of high temperature heat pump drying machine is the use of the principle of inverse Kano, the absorption of air heat and its transfer to the housing, the temperature of the drying room to improve, with the corresponding equipment to achieve the drying of material. The high temperature heat pump dryer is composed of a compressor, a heat exchanger (inner machine), a throttle device, an air receiver, and a compressor. Cold medium circulating flow in the system under the action of the compressor. It is completed in the compressor gas temperature rise process (up to 100 C), it enters the internal machine to release a high temperature heat within the air, while being cooled and transformed into liquid, when it runs to the outside, the liquid quickly endothermic evaporation once again into the gas, while the temperature dropped to minus 30 degrees Celsius, then the heat transfer to the cold media. Cold media continue to cycle to achieve the heat in the air to the drying room heating room air temperature. Application drying, drying from ancient times to the present widely used in industry, agriculture, chemical industry, drying technology and our production and living is closely related to. Along with the low carbon life, the demand of green ecology, the protection of the environment is more and more strong, and the shortage of non renewable energy resources. Use of fuel, coal and other high energy consumption, high pollution drying equipment has been severely restricted or even prohibited. To find an alternative to the original old drying equipment, and safety, environmental protection, energy saving dryer, it seems more and more urgent. Bilang air and high temperature heat pump drying equipment emerge as the times require in this environment. History of high temperature heat pump drying technology was first originated in Japan, France and other developed countries, Bilang company first introduced the technology and the earliest application in wood drying, as almost a natural drying heat pump drying temperature is low, in recent years gradually applied to food and agricultural products drying operation, and achieved good economic benefit and product added value is greatly improved. Now, the high temperature heat pump drying equipment came into being, especially the implementation of the government's energy saving and environmental protection policies, greatly promoting the development of heat pump drying technology. Four 1 advantages of safety, environmental protection: drying room is not in contact with electricity, no electric shock hazard, using a small amount of electricity as a driving energy without any pollution, saving more than 60% of electricity direct heating. 2. Good drying effect: Bilang heat pump drying room adopts PLC (monitor) the eighth generation circuit board controller, adjustable temperature, humidity arbitrary effectively grasp the different drying temperature, humidity, drying time, high requirements of the food and agricultural and sideline products fineness beautiful, beautiful outlook, keep food authentic, keep: product color, nutrition, flavor and organizational. Increase product added value. 3 high efficiency and energy saving, low operating cost. The prospect of high temperature heat pump drying technology has the advantages of less energy consumption, less environmental pollution, high drying quality and wide application scope. The Bilang high temperature heat pump drying equipment is moving towards increasing drying temperature. Now, Bilang spontaneously developed high temperature heat pump drying equipment can reach as high as 95 degrees, eighth generation heat pump drying circuit board control system has been developed, preparations for the development of the ninth generation of high temperature heat pump drying circuit board control system and heat pump automatic control technology development and high temperature heat pump drying as can reduce energy consumption and technology to improve product quality and perfect unity between will bring major technological revolution in the drying industry, Bilang company will continue to lead the high temperature heat pump drying industry!. 4. To save the labor cost: (now many bosses often difficult to recruit, hard to train talents, retain talents harder) only change idea of the boss will solve these problems: must use the device instead of human, with advanced drying equipment, to create a first-class production hardware, let the machine for us to make money, Bilang high temperature heat pump drying room, so long as to begin! Achieve full automatic drying, the middle does not require any person to operate!