Qingzhou Kaixiang sand mining machinery Co., Ltd   

This is a set of gold unit, wherein the gold link uses is agitating chute. Agitating chute is a new type of placer gold research coming out of the ordinary fixed groove based on the selected device. It synthesizes the advantages of fixed chute and jig, overcome the fixed groove is easy to harden the shortcomings and deficiencies were jigging machine, thus the yield obtained small and not easy to harden this characteristic. The characteristics of the agitating chute basically retains the original characteristics of fixed chute, and the iron bottom plate original changed to rubber floor, plus the crank connecting rod mechanism is simple, so that the rubber bottom plate to do reciprocating motion on, under, each slide effect similar to the diaphragm between the lattices of jigging machine. To solve the hardening phenomenon of riffle, improve the recovery rate of gold. The agitating chute is intermittent discharge of concentrate, so yield is very small, the enrichment ratio than jig high tens to hundreds times. According to the different amount of agitation chute treatment, can be divided into KXGL-12-3, KXGL-12-4, KXGL-15-4, KXGL-12-5, KXGL-15-5 several models, the processing capacity of 12 cubic meters / hour, 20 cubic meters / hour, 30 cubic meters / hour, 30 cubic meters / hour, 35 cubic meters / hour respectively. Structure of placer gold King peristaltic chute has the advantages of reasonable and simple setting, maintenance is also very simple, first, tank cleaning, check regularly for rubber frayed or pricked place, is very simple, just have a look at the bottom there is no Water Leakage or seepage can be, if there is a wound, to timely repair or replacement, if there is a small prick the location, not too close to the angle steel, can be used to supplement the Interim Measures for the bicycle tyre mending, repair skin can be used very thin bicycle inner tube or latex gloves. Second, pay attention to each weld has no open welding place, connecting rod screw is loose. Third, don't walk and placed heavy or sharp objects on the groove face, don't put grease, alkaline acid onto the rubber, so as to avoid the corrosion of rubber. Fourth, do not have to place a long time, some of the sand is best placed in the slot, so as to avoid the rubber insolation weathering. Fifth, do a good job of lubrication work, often smearing butter and check reducer gear oil, butter will take about 15 days to check the smear, gear oil to check every 3 months.

Gold equipment, ship, dredger, small pumping vessel, agitating chute